APC BACK-UPS 1400VA, AVR, Schuko SocketsBattery Backup & Surge Protector for Electronics and Computers
Automatic restart of loads after UPS shutdown Automatically starts up the connected equipment upon the return of utility power.
Automatic self-test Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Automatic Voltage Regulation (AVR) Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.
Resettable circuit breaker Easy recovery from overloads; no need to replace a fuse.
Telephone dataline surge protection Provides protection of connected equipment from power surges traveling on telephone lines.
USB connection Use your PC to access additional power protection and management features for your UPS via a USB Port.

Τεχνικά Χαρακτηριστικά:

Output
  Output power capacity 700Watts / 1.4 kVA
  Max Configurable Power (Watts) 700Watts / 1.4 kVA
  Nominal Output Voltage 230V
  Output Frequency (sync to mains) 50/60 Hz +/-1 Hz
  Output Frequency (not synced) 50/60 Hz +/-1 Hz
  Topology Line Interactive
  Waveform type Stepped approximation to a sinewave
  Output Connections (4) Schuko CEE 7 (Battery Backup) Transfer Time 8ms typical : 10 ms maximum

Input
  Nominal Input Voltage 230V
  Input frequency 50/60 Hz +/- 3 Hz (auto sensing)
  Input Connections Schuko CEE 7/7P
  Cord Length 1,22meters
  Input voltage range for main operations 150 – 280 V
  Number of Power Cords 1
  Type of Input Protection Required 3-pole breaker
  Maximum Input Current 6.0A
  Input Power Factor at Full Load 0.5

Batteries & Runtime
  Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
  Typical recharge time 8hour(s)
  Replacement Battery APCRBC113
  Expected Battery Life (years) 2 – 5
  Battery Volt-Amp-Hour Capacity 165

Communications & Management
  Control panel LED status display with On Line : On Battery : Replace Battery and Overload indicators
  Audible Alarm Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
Surge Protection and Filtering
  Surge energy rating 273Joules
  Data Line Protection RJ-11 Modem/Fax protection

APC BACK-UPS 950VA, Schuko Sockets
Battery Backup & Surge Protector for Electronics and Computers

Automatic restart of loads after UPS shutdown Automatically starts up the connected equipment upon the return of utility power.
Automatic self-test Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Automatic Voltage Regulation (AVR) Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.
Resettable circuit breaker Easy recovery from overloads; no need to replace a fuse.
Telephone dataline surge protection Provides protection of connected equipment from power surges traveling on telephone lines.
USB connection Use your PC to access additional power protection and management features for your UPS via a USB Port.

Τεχνικά Χαρακτηριστικά:

Output
  Output power capacity 480Watts / 950VA
  Max Configurable Power (Watts) 480Watts / 950VA
  Nominal Output Voltage 230V
  Output Frequency (sync to mains) 50/60 Hz +/-1 Hz
  Output Frequency (not synced) 50/60 Hz +/-1 Hz
  Topology Line Interactive
  Waveform type Stepped approximation to a sinewave
  Output Connections (4) Schuko CEE 7 (Battery Backup) Transfer Time 8ms typical : 10 ms maximum

Input
  Nominal Input Voltage 230V
  Input frequency 50/60 Hz +/- 3 Hz (auto sensing)
  Input Connections Schuko CEE 7/7P
  Cord Length 1.22meters
  Input voltage range for main operations 150 – 280 V
  Number of Power Cords 1
  Type of Input Protection Required 3-pole breaker
  Maximum Input Current 4.0A
  Input Power Factor at Full Load 0.51

Batteries & Runtime
  Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
  Typical recharge time 8hour(s)
  Replacement Battery RBC17
  Expected Battery Life (years) 2 – 5
  Battery Volt-Amp-Hour Capacity 76

Communications & Management
  Control panel LED status display with On Line : On Battery : Replace Battery and Overload indicators
  Audible Alarm Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
  Surge Protection and Filtering Surge energy rating 273Joules
  Data Line Protection RJ-11 Modem/Fax protection

APC BACK-UPS 700VA, SCHUKO Sockets
Battery Backup & Surge Protector for Electronics and Computers
Includes : User Manual
Automatic Voltage Regulation (AVR) Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.
USB connection Use your PC to access additional power protection and management features for your UPS via a USB Port.
Back-UPSFeatures & Benefits

Manageability
LED status display Quickly understand unit and power status with visual indicators. Audible alarms Provides notification of changing utility power and UPS power conditions

Availability
Intelligent battery management Maximizes battery performance, life, and reliability through intelligent, precision charging. Battery failure notification Provides early-warning fault analysis on batteries enabling timely preventive maintenance Automatic self-test Periodic battery self-test ensures early detection of a battery that needs to be replaced.

Protection
Battery and surge protected outlets Back up and protect your hardware and data during power outages, surges and spikes. Surge only outlets Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.

Marketing Features
Battery-protected and surge-only outlets Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment

Safety
Safety-agency approved Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

Τεχνικά Χαρακτηριστικά:

Output
Output power capacity 390Watts / 700VA
Max Configurable Power (Watts) 390Watts / 700VA
Nominal Output Voltage 230V
Output Frequency (sync to mains) 50/60 Hz +/-1 Hz
Topology Line Interactive
Waveform type Stepped approximation to a sinewave
Output Connections (4) Schuko CEE 7 (Battery Backup) Transfer Time 4ms typical

Input
Nominal Input Voltage 230V
Input frequency 50/60 Hz +/- 3 Hz (auto sensing)
Input Connections Schuko CEE 7/7P
Cord Length 1.52meters
Input voltage range for main operations 140 – 300V
Number of Power Cords 1

Batteries & Runtime
Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time 6hour(s)
Replacement Battery APCRBC110
Expected Battery Life (years) 3 – 5
Battery Volt-Amp-Hour Capacity 81

Communications & Management
Control panel LED status display with On Line : On Battery : Replace Battery and Overload indicators
Audible Alarm Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
Surge Protection and Filtering Surge energy rating 273Joules

APC Back-UPS 400,
Battery Backup & Surge Protector for Electronics and Computers
Includes : User Manual , Wall-mounting template
Audible alarms Provides notification of changing utility power and UPS power conditions
Automatic self-test Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Battery failure notification Provides early-warning fault analysis on batteries enabling timely preventive maintenance
Battery-protected and surge-only outlets Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment
Resettable circuit breaker Easy recovery from overloads; no need to replace a fuse.
Safety-agency approved Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
User-replaceable batteries Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)

Τεχνικά Χαρακτηριστικά:

Output power capacity 240Watts / 400VA
Max Configurable Power (Watts) 240Watts / 400VA
Nominal Output Voltage 230V
Output Frequency (sync to mains) 47 – 63 Hz
Output Frequency (not synced) 50Hz +/- 0.1% for 50Hz nominal
Topology Standby
Waveform type Stepped approximation to a sinewave
Output Connections  (4) Schuko CEE 7 (selector_surgetitle), (4) Schuko CEE 7 (Battery Backup) Transfer Time 6ms typical : 10ms maximum

Input:
Nominal Input Voltage 230V
Input frequency 50/60 Hz
Input Connections Schuko CEE 7/7P
Cord Length 1.83meters
Input voltage range for main operations 180 – 266V
Number of Power Cords 1
Maximum Input Current 10.0A

Batteries & Runtime:
Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time 16hour(s)
Replacement Battery APCRBC106
Expected Battery Life (years) 2 – 5
RBC Quantity 1
Βattery Volt-Amp-Hour Capacity 102
Communications & Management:
Control panel LED Status display with On Line : On Battery
Audible Alarm Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm

Surge Protection and Filtering:
Surge energy rating 310Joules
Data Line Protection Analog phone line for phone/fax/modem/DSL (RJ-11 connector), Network line – 10/100 Base-T Ethernet (RJ-45 connector)
Filtering Full time multi-pole noise filtering : 5% IEEE surge let-through : zero clamping response time : meets UL 1449

Για την καλύτερη ενημέρωση σας και εξυπηρέτηση παρακαλούμε επικοινωνήστε μαζί μας στα τηλέφωνα 210 3845272 και 210 3845676 για προιόντα και τιμές που δεν αναφέρονται ή επισκεφθείτε μας ξανά για περισσότερα νέα προϊόντα και υπηρεσίες.

Επίσης με χαρά θα θέλαμε να μας δώσετε (στείλετε) τη γνώμη σας και τις υποδείξεις σας στο

e-mail : sales@hifipower.gr.

Ευχαριστούμε για την βοήθεια και την κατανόηση,